Getting Burned Oil Off Stainless Steel Pan Dryer Sheet

Be sure to rinse thoroughly and towel dry.

Getting burned oil off stainless steel pan dryer sheet.

Soak a burnt pan with soap and water and add a dryer sheet into the mix. Most of the burned on part will rinse off then use sos or scrubby to finish the job. I used the dryer sheet to scrub the extra bits and they came off right away too. Just by running it under water about 80 percent of the burnt pieces detached.

If it is a small pan or pot and if the oil is sticking to the bottom of the pan the best thing to do is to fill the pan slightly with white vinegar which will cover the area where there is the oil residue. Substances such as baking soda salt and toothpaste contain gritty materials that help remove built up and burnt oil without containing enough grit to damage stainless steel. While it is possible to remove the oil it will take time and effort. Soak a dryer sheet.

Put the pan in a plastic bag and seal with twist tie. Even the little bits of splattered burnt grease at the top of the pan came off. That has been very successful for me. The dryer sheet which can be substituted for a tablespoon of fabric softener will loosen the burnt on food and leave you with a shiny like new pan.

Wash the pan lightly with water and spray white vinegar. To find out we abused four stainless steel skillets by slicking them with several tablespoons of oil and heating them until it smoked and burned onto their surfaces. Make a paste with baking soda and water creating a substance comparable to that of toothpaste. Try using a dryer sheet with some water in the pan.

Prepare your work space with an area to soak the pan a well ventilated area to work and plenty of clean water to wash and rinse it afterwards. Allow it to sit for an hour. This video shows you how you can use warm water dish soap a dryer sheet and a little patience to easily remove burned on stuck on food from a pan. Rub in circular motions.

Seriously they flaked off with minimal effort on my part. To further solder this resin to the pans we then baked the skillets in a 500 degree oven for a few hours. A fabric softener sheet can be a surprising miracle worker for burnt bits we ve seen it in action. If that doesn t work try a stainless steel cleaner but read the label carefully.

Leave the pan with white vinegar for at least half an hour or a couple of hours.