General troubleshooting tips for what to check when your genie garage door opener is not working below.
Genie garage door opener light won t turn off.
Disconnect the wiring from the opener.
The problem is either due to a blocked path between the sensors dirty eyes loose wires at the sensors or at the motor head or just bad sensors.
Allow roughly 10 minutes to troubleshoot your garage door opener.
The transmitters remotes will not work to close the garage door.
Explore our product and support offerings today.
If you are standing behind the opener looking towards the door the board will be on the top left side.
To small screws at the very bottom of the cover and then one on the left and top right.
After 90 seconds reconnect the power and see if the lights come on.
Try these steps to fix the issue.
Disconnect the unit power.
If the beam has been crossed multiple times it can give the appearance of a light that won t turn off.
If you have a multi function door control it may have a motion detection feature.
The safety light feature will activate the lights when the door is open and the safety sensors are crossed.
Reset the light timer to the lowest setting 90 seconds instead of 4 minutes.
Slide the cover off.
Genie garage door opener systems accessories and installations are well known and trusted by consumers.
The only way to fix it is to put a board in it.
Step 1 remove the indoor control panel from the wall and use a philips head screwdriver to disconnect and reconnect the wiring.
More specifically if your garage door light won t shut off it is most likely due to one of these reasons.
It is simple to put a board in.
Garage door lights sometimes malfunction.
Pull the cover off.
You will find that the door will only move an inch or so in the close direction and reverse.
Then reconnect the opener.