Genie Garage Door Keeps Opening And Closing

In garage door operators made after 1993 there are required safety features that open the door during the close cycle when they detect something blocking the door.

Genie garage door keeps opening and closing.

Open the garage door and watch it closely as it opens. Get logic board replacement. This is done with the help of sensors in the motor and on each side of the opening near the floor and mounted on the tracks. These limits set the distance the door will open or close before stopping.

If it is be sure that the lenses are mounted five to six inches from the floor on either side of the garage door opening. When the garage door opens about halfway or 5 feet from the ground and stops the up limit switch needs to be adjusted. The likely culprit is an obstruction in the path of the garage door. In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.

In the down direction if the limit is set beyond the point at which the door closes fully the door will hit the floor and act as if it is hitting something and the safety feature tells it to reverse. If an operational problem exists and the garage door opener will not close the opener can be forced to close. Check for and clear any obstructions in its way. Check for interference from adjacent photo eye sensors of any brand.

Check garage door for binding. Your garage door s logic board is the brain of your garage door opener. You have an open limit and a close limit on your garage door opener. Press and hold the wall console button until the garage door is completey closed.

How to fix a garage door that keeps reversing. If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch. Door starts down then stops before it is closed. If the problem persists check to see if the red safe t beam led indicator is blinking.

You push the button to close the garage door. This brain can wear out in time so you could need a replacement. It goes partway down reverses direction and goes back up again. This is actually a very rare problem of all the garage door installation problems you can have but when it happens it s usually a short in the circuit board says andrew richards owner of legacy.