It either eliminates or greatly reduces the issue of weakened remote signal to your opener that common led bulbs can cause.
Genie garage door issue programming remote led stays.
To program the remote to your genie garage door opener you need to have it close to the garage door opener so it s within frequency range.
Make sure only the safe t beams that came with this garage door opener are installed.
You should now be able to operate the door using your genie garage door opener.
This small black unmarked button is located behind the light lens at the motor head and is nearest the floppy 6 inch antenna wire that protrudes from the motor head.
If it is a new installation check the postion of the door arm.
Also make sure there are no people pets vehicles or other obstructions in the path of the garage door.
Check if the limits are.
It also has the added advantage of being shatter vibration resistant.
Genie garage door opener programming instructions here at genie of fairview door co our customers have relied on us to help install set up and reprogram garage door opener systems since 1964.
Before you call us though you may be able to self diagnose and solve a hand held remote programming issue on your own.
Programming genie intellicode remote transmitters gently press and release the receiver learn code button on the power head receiver of your door operator.
Then locate the learn code button which is usually near the antenna and the led indicator.
To solve the issue genie has developed its own led light bulb designed specifically for almost any brand of garage door opener.